THIS AUGER MOTOR IS USED ON SOME OLDER PELLET STOVES AND ALL OF THE P6000 HEARTLAND MULTI-FUEL STOVES.

P6000 HEARTLAND MULTI-FUEL - All Units

Pellet Stoves
This auger motor was used on most of the older pellet stoves with the analog control panel, and some of the early digital control panel units.  For the older analog control panel stoves look at your heat level settings to determine if this is the auger motor you need.  If your heat level settings on the control panel are one of the following, then you would use this auger motor:
1, 2, 3, 4, Max or if they are Low, B, C, D, E, Max

If the heat level settings on your analog control panel is High, Med, Low or if they are Low, B, C, High, then you will need the C-E-017M Auger Motor instead of this one.

Some of the first digital control panels (all push button with heat levels 1, 2, 3, 4, 5) also used this 4 RPM auger motor.  Below you will find a list of model and serial numbers.  Use this to determine if you need this auger motor.
P23 Sonoara - 6332 to 7165
P23I Sonora Insert - 1916 to 2242
P24 Blazer - 53319 to 53663
P24I Blazer Insert - 53220 to 53794
P2000 Tahoe - up to 11779
P2000I Tahoe Insert - up to 22207
P2700 Mojave - 7900 to 8444

ADDITIONAL INFORMATION

Serial numbers are approximate and should not be the only source of validation for the part.  Serial numbers may be off by as much as 10 units either way.